First I tried putting it on mandrel and bending it back in shape. It didn't work so I annealed it, straightened it out and etched it.
Unfortunately I didn't have enough etchant in the container and the middle section of the bracelet made contact with the bottom of the container. This section didn't etch well compared to the rest. The bracelet did shape up nicely on the mandrel after the annealing though. The top of the bracelet, the part most visible, had very little etching and what it did have was very shallow. Okay, I decided, this was not a bracelet I could sell.
Then I found a brass butterfly woman stamping. I had previously experimented with bending this stamping with my bracelet bending pliers but hadn't done anything with it. I decided to rivet it to the top of the cuff.
This was tricky. The stamping had an open back and I had to be careful not to crush it. Also, it was difficult to rivet the wings because of the curvature of the cuff and because the rivet heads were somewhat recessed on the front of the wings. I used my smallest hammer and a nail punch that I found at Lowes. I balanced the cuff on the punch with the top of the rivet seated in the hollow of the punch, and very carefully tapped the rivet on the inside of the cuff. It worked. The stamping nicely covered the shallow area of the etching.
I would never have done this if I hadn't made a mistake with the etching. Some of my most creative and satisfying work comes out of a mistake I've made.
I still can't sell it: I like the cuff so well I'm keeping it for myself.
